Calibration Foil Standards

Paint Test Equipment Calibration foils are necessary for the day to day calibration checking of Coating Thickness Meters.

Each individual foil is measured in the centre and the value is written on the label and is supplied in a strong robust wallet which allows protection of each foil from dirt, grease etc.

The foils are supplied as a set of 8 foils and can be either the standard set:
Part No F1009 of  25 / 50 / 75 / 125 / 175 / 250 / 500 / 750 micron or alternatively a special set can be supplied made up of any 8 values as listed below which will cater for more specialised measurement ranges.

12µm / 25µm / 37µm / 50µm / 63µm / 75µm / 100µm / 125µm / 150µm / 175µm / 190µm / 200µm / 225µm / 250µm / 275µm / 300µm / 350µm / 375µm / 500µm / 625µm / 750µm / 1000µm / 1250µm / 1500µm / 2000µm / 3000µm / 5mm / 9.5mm / 15mm

Note all values shown are nominal values

Calibration certificates are available for each foil set showing traceability of measurement to UKAS

Part No F1009 - Standard Foil Set 8 foils                           
Part No F1002 - Foil set calibration certificate                  
Part No Z1003 - Precision Ground Steel Zero Disk           
Part No Z1004 - Precision Aluminium Zero Disk

See alsoo Eban1000, Eban2000Mk2, Eban3000Mk2 Coating Thickness Meters

Data Sheet: Download Data Sheet