Cross Hatch Cutter

The Paint Test Equipment Cross Hatch Cutter will allow an assessment to be made of the adhesion resistance of coatings to separation from substrates when a right angled lattice pattern is cut into the coating and penetrates through to the substrate.

The coating thickness determines the Cutter size used. The 1mm Cutter is suitable for coatings under 60 microns, the 2mm cutter is suitable for coatings over 60 microns.

Simple operation, each Cross Hatch Cutter has 6 cutting blades spaced either 1mm or 2mm apart, one cutting pass makes 6 cuts in the coating, a second pass at 90° makes a square lattice pattern.

Apply Adhesive Tape over cut section and within 5 minutes remove tape.

Classify the cut area according to the relevant national standard classification guide.

The cutting blades are ground onto 6 cutting sides, so that when one cutting side becomes blunt there are a further 5 cutting sides to use.
Therefore giving a 1/3 rd extra life over conventional 4 sided models.

This Cutter complies with ISO, BS, DIN and ASTM methods of measurement.

Supplied in a Carrying Case

Part Numbers
X2001 - 1mm cutters for coatings under 60 micron
X2002 - 2mm cutters for coatings over 60 micron Accessories
XA001 - Adhesion Tape complies with ISO2409
XA002 - Viewing Lens complies with ISO2409

See also HATE Hydraulic Adhesion Test, Crosshatch Cutter Accessories

Data Sheet: Download Data Sheet