Surface Profile Gauge Analogue

The Paint Test Equipment Surface Profile Gauge will allow the peak to valley height of blast cleaned surfaces to be accurately measured in accordance with the ASTM standard

The gauge is initially set to zero with the glass zero plate and the foot is then placed on the blasted profile.

The foot sits on top of the peaks and the sharp stylus travels to the bottom of the valley, allowing the gauge to display the peak to valley height.

A number of measurements can be made and the average taken.

In addition the gauge can also be used to measure the effects of corrosion, i.e. pitting and cavity depth etc.

Smallest measurement on scale is 2 micron.

Supplied in Carrying Case with Glass Zero Plate.

Part Number
R1005 - Analogue Profile GaugeAccessories
NR002 - Calibration Certificate UKAS traceable

See also Surface Profile Gauge Digital, Testex Tape

Data Sheet: Download Data Sheet